KLEEN-AIR

Related products

• CHEMICALS

  COIL TAMER-PINK STUFF (ACIDIC) 1 Gal

  

  Quick view

  $15.55

  Pink Stuff
  HS58128 1 Gal. Plastic Bottle
  Heavy Duty, Foaming, Acid Based Concentrated Liquid Coil Cleaner
  Foaming Action Pushes Dirt Out of Coils to be Rinsed Away.
  • Non Flammable
  • Biodegradable • Easy to Use
  • Non Oily

  Cleans and Brightens:
  • Condenser Coils
  • Equipment Surfaces
  • Evaporator Coils

  Effective On
  • Heavy Oxidation
  • Lint
  • Grease
  • Algae • Oily Dirt
  • Mold
  • Mildew
  • Oils

  Add to cart
• CHEMICALS

  MAINSQUEEZE WITHOUT PUMICE 8 oz Tube

  

  Quick view

  $3.45

  Mainsqueeze
  HS41008 8 oz Tube w/o Pumice
  Industrial strength citrus hand cleaner • Safe
  • Moisturizes and Conditions
  • Water Rinse or can be Wiped Dry
  • Biodegradable
  • Refreshing and Pleasant Scent
  Twice the cleaning power of any other hand cleaner.
  Citrus Terpenes and other natural emollients to cut
  through the tough, hard to remove elements.
  • Dirt
  • Odors
  • Resins
  • Inks
  • Grease
  • Grime
  • Paints
  • Rubber, Gasket and Tile Cements
  Available with or without pumice in 8 oz. pocket squeeze
  tube or 1 gallon portable container with pump dispenser

  Add to cart
• CHEMICALS

  ACID TESTER

  

  Quick view

  $15.22

  Acid Test Kit
  Tests for damaging acid in refrigerants
  • Kit contains 5 acid pads and solution for 20 tests
  • Economical and easy to use
  • Test requires only one drop of refrigerant oil
  • Test takes one minute
  • Gas does not have to be evacuated from compressor

  Acid in a system can cause:
  • Clogged cap tubes
  • Defective fan motors
  • Dirty condensers
  • Defective run capacitors
  • Low voltage
  • Cycling of overloads
  • Open start capacitors
  • Defective start relays

  Add to cart
• CHEMICALS

  TAN EPOXY PUTTY 4″

  

  Quick view

  $8.97

  Epoxi Putty
  9900H Tan Epoxy Putty 4 inch blocks
  • Cures Wet or Dry – will cure underwater
  • Mixes like clay hardens like steel
  • After curing, can be sanded, drilled, tapped, machined, sawn, or painted.
  • Initial set in 10 to 15 minutes, hard set 1 hour, with full cure in 24 hours.
  • Temperature range -65 F to +250 F
  • Works on glass, wood, plastic, fiberglass, tile, concrete, and many more.

  Add to cart